Miniaturized Bandpass Filter Using the Metamaterial Half-Mode Technique for Substrate Integrated Waveguide | IJCSE Volume 10 β Issue 5 | IJCSE-V10I5P37
IJCSE
International Journal of Computer Science Engineering Techniques
ISSN 2455-135X Β· Peer-Reviewed Β· Open Access
π Volume 10, Issue 5
π
October 16, 2026
π Pages 281β286
π ID: IJCSE-V10I5P37
Table of Contents
ToggleMiniaturized Bandpass Filter Using the Metamaterial Half-Mode Technique for Substrate Integrated Waveguide
Author(s)
Rand Muaffaq Hadi
Abstract
In this paper, a half-mode evanescent substrate integrated waveguide (SIW) bandpass filter is proposed. The proposed filter operates below the cutoff frequency of the conventional SIW by adopting the metamaterial technique. The operating frequency of the full-mode substrate integrated waveguide (FM-SIW) is 2.2 GHz, while the cutoff frequency of the conventional SIW structure is 5.2 GHz. Fractal slots are cut from the broad wall of the SIW. First-, second-, and third-order bandpass filters are designed, simulated, fabricated, and experimentally validated using a vector network analyzer. The metamaterial technique achieves a miniaturization of about 60% relative to the conventional SIW structure, and the responses are compared with those of its FM-SIW counterpart, with no obvious difference observed. The half-mode SIW (HM-SIW) technique is then used to achieve further miniaturization of about 50% relative to the original FM-SIW structure. The measured one-stage filter covers the 2.4 GHz ISM band with an insertion loss of about 1.2 dB and a return loss of about 40 dB, and cascading additional unit cells is shown to sharpen the filter’s selectivity while preserving close agreement between simulation and measurement. Finally, the simulation and measurement results agree well with other work in the literature.
Keywords
bandpass filter, fractal slot, half-mode substrate integrated waveguide (HM-SIW), metamaterial, substrate integrated waveguide (SIW)
Conclusion
This work demonstrated a compact bandpass filter built on a half-mode substrate integrated waveguide loaded with metamaterial fractal slots. The slots allow the guide to pass a band well below its natural 5.2 GHz cutoff, and halving the structure reduces its footprint by a further 50% without degrading the response. Extracted permittivity and permeability confirm the metamaterial behavior, with forward- and backward-wave regions appearing next to each other. Prototypes of one, two, and three cascaded stages were built on FR4 and measured; their responses match the simulations closely, and adding stages steepens the band edges while leaving the center frequency and losses nearly unchanged. Combining a small size, a simple single-layer PCB process, and low loss, the proposed filters are well suited to compact wireless front ends.
References
[1] S. H. Han, X. L. Wang, Y. Fan, Z. Q. Yang, and Z. N. He, "The generalized Chebyshev substrate integrated waveguide diplexer," Progress In Electromagnetic Research, vol. 73, pp. 29β38, 2007.
[2] D. Deslandes and K. Wu, "Accurate modelling, wave mechanisms, and design considerations of a substrate integrated waveguide," IEEE Trans. Microw. Theory Tech., vol. 56, no. 6, pp. 2516β2526, 2006.
[3] B. Liu, W. Hong, Y. Zhang, H. Tang, X. Yin, and K. Wu, "Half mode substrate integrated waveguide 180Β° 3-dB directional couplers," IEEE Trans. Microw. Theory Tech., vol. 55, no. 12, pp. 2586β2592, 2007.
[4] J. P. Liu, Z. Q. Lv, and X. An, "Compact substrate integrated waveguide filter using dual-plane resonant cells," Microw. Opt. Technol. Lett., vol. 58, no. 1, pp. 111β114, 2016.
[5] B. Mansouri, M. Abri, H. Abri, M. A. Rabah, J. Tao, and T.-H. Vuong, "SIW bandpass filter screens S-band signals," Microwaves RF, vol. 54, no. 3, pp. 62β66, 2015.
[6] A. Parameswaran and A. P. S. Raghavan, "Miniaturizing SIW filters with slow-wave technique," AEU β Int. J. Electron. Commun., vol. 84, pp. 360β365, 2018.
[7] B. Liu, W. Hong, Y. Zhang, H. Tang, X. Yin, and K. Wu, "Half mode substrate integrated waveguide 180Β° 3-dB directional couplers," IEEE Trans. Microw. Theory Tech., vol. 55, no. 12, pp. 2586β2592, 2007.
[8] Y. Dong and T. Itoh, "Composite right/left-handed substrate integrated waveguide and half-mode substrate integrated waveguide," IEEE MTT-S Int. Microw. Symp. Dig., pp. 49β52, 2009.
[9] M. DurΓ‘n-Sindreu, J. Bonache, F. MartΓn, and T. Itoh, "Single-layer fully-planar extended-composite right/left handed transmission lines based on substrate integrated waveguides for dual-band and quad-band applications," Int. J. Microw. Wireless Tech., vol. 5, pp. 213β229, 2013.
[10] T. Yang, P. Chi, R. Xu, and W. Lin, "Folded substrate integrated waveguide based composite right/left-handed transmission line and its application to partial H-plane filters," IEEE Trans. Microw. Theory Tech., vol. 61, no. 2, pp. 789β799, 2013.
[11] H. Kumar, R. Jadhav, and S. Ranade, "A review on substrate integrated waveguide and its microstrip interconnect," J. Electron. Commun. Eng., vol. 3, no. 5, pp. 36β40, 2012.
[2] D. Deslandes and K. Wu, "Accurate modelling, wave mechanisms, and design considerations of a substrate integrated waveguide," IEEE Trans. Microw. Theory Tech., vol. 56, no. 6, pp. 2516β2526, 2006.
[3] B. Liu, W. Hong, Y. Zhang, H. Tang, X. Yin, and K. Wu, "Half mode substrate integrated waveguide 180Β° 3-dB directional couplers," IEEE Trans. Microw. Theory Tech., vol. 55, no. 12, pp. 2586β2592, 2007.
[4] J. P. Liu, Z. Q. Lv, and X. An, "Compact substrate integrated waveguide filter using dual-plane resonant cells," Microw. Opt. Technol. Lett., vol. 58, no. 1, pp. 111β114, 2016.
[5] B. Mansouri, M. Abri, H. Abri, M. A. Rabah, J. Tao, and T.-H. Vuong, "SIW bandpass filter screens S-band signals," Microwaves RF, vol. 54, no. 3, pp. 62β66, 2015.
[6] A. Parameswaran and A. P. S. Raghavan, "Miniaturizing SIW filters with slow-wave technique," AEU β Int. J. Electron. Commun., vol. 84, pp. 360β365, 2018.
[7] B. Liu, W. Hong, Y. Zhang, H. Tang, X. Yin, and K. Wu, "Half mode substrate integrated waveguide 180Β° 3-dB directional couplers," IEEE Trans. Microw. Theory Tech., vol. 55, no. 12, pp. 2586β2592, 2007.
[8] Y. Dong and T. Itoh, "Composite right/left-handed substrate integrated waveguide and half-mode substrate integrated waveguide," IEEE MTT-S Int. Microw. Symp. Dig., pp. 49β52, 2009.
[9] M. DurΓ‘n-Sindreu, J. Bonache, F. MartΓn, and T. Itoh, "Single-layer fully-planar extended-composite right/left handed transmission lines based on substrate integrated waveguides for dual-band and quad-band applications," Int. J. Microw. Wireless Tech., vol. 5, pp. 213β229, 2013.
[10] T. Yang, P. Chi, R. Xu, and W. Lin, "Folded substrate integrated waveguide based composite right/left-handed transmission line and its application to partial H-plane filters," IEEE Trans. Microw. Theory Tech., vol. 61, no. 2, pp. 789β799, 2013.
[11] H. Kumar, R. Jadhav, and S. Ranade, "A review on substrate integrated waveguide and its microstrip interconnect," J. Electron. Commun. Eng., vol. 3, no. 5, pp. 36β40, 2012.
π How to Cite This Paper
Rand Muaffaq Hadi (2026). Miniaturized Bandpass Filter Using the Metamaterial Half-Mode Technique for Substrate Integrated Waveguide. International Journal of Computer Science Engineering Techniques, 10(5), 281β286. ISSN: 2455-135X. DOI: https://doi.org/10.5281/zenodo.23420953

